Subaru 86510FG011 Motor & Link Assembly Windshield

First wiper motor and linkage, Begin the removal of the cable from battery terminal that is negative. Take off each windshield wiper arm's protective cap. Take off each windshield wiper arm's protective cap carefully using a prying tool. Remove nuts securing each wiper arm to its shaft. Remove nuts for the wiper arm shafts. Each wiper arm must be marked relative to its shaft. Mark the relationship between the arm and its shaft so as to keep track while installing it again. The next step is removing the arms of the windshields. Next, remove cowl cover. Disconnect electrical connector from wiper motor there after remove retaining bolts and nut from assembly of linkage and wiper motor assembly (left side shown, right side similar) take out assembly by lifting out through cowl plenum panel.Windshield Wipers Motor Electrical Connector And Linkage Assembly Mounting Bolts(Left Side Shown, Right Side Similar), And Lift Assembly From Cowl.Separate your linkage assembly from your engine. For removing crank arm nut marking point where crank arm contacts mounting bracket remove crank arms then take away mounting bolts for your engine.Installation in reverse order.Rear Wiper Motor (Wagon/Hatchback Models), To begin with, detach negative terminal of cable from battery.Flip up on your windshield washer nozzle cover.Remove a nut that holds a wiper blade on a motor shaft.Take off Wiper Arm Nut To Shaft.Mark this relationship between these two things so as to make sure you can put them back just like before.Arm should be taken out by detaching it from its shaft.Refer to Installation Sequence for Spacers and Cushion.Note installation sequence of spacers and cushion used.The liftgate trim panel must be removed too.Electrical wires need also disconnected.Wipe Engine Electric Connector And Fixations.Installment Of Wipe Engine Electric Connector As Well As Removal Of Bolt Holes For Wipe Engine.Correct Assembly.