Subaru 27111FE130 Drive Shaft Assembly

You can Select Your Vehicle to check if 27111FE130 fits your vehicle.

Pull the sleeve yoke out of the extension housing.Remove the driveshaft.Plug the extension housing to prevent contaminants from entering.

The driveshaft transmits power between the transaxle and the rear differential, employing a splined sleeve yoke at the front end and bolted to the differential pinion flange at the rear end. Universal joints are located at either end of the driveshaft, and a third U-joint is installed behind the center bearing, which is a ball-type bearing mounted in a rubber cushion attached to the vehicle floorpan. All models are equipped with a pair of front axle shafts and two rear axle shafts, consisting of an inner and outer ball-and-cage type CV joint connected by an axleshaft, or a tri-pot inner joint and a ball-and-cage outer joint. The inner CV joint can be disassembled, while the axleshaft and outer CV joint are a single assembly and cannot be disassembled. The driveshaft assembly requires very little service, and problems with the driveshaft are usually indicated by a noise or vibration while driving the vehicle.