How to perform an oil and oil filter change and properly disposing of the used oil on Subaru Outback?

The engine is best served by having the oil changed regularly because with time, the old oil becomes diluted and contaminated causing a premature engine wear. Make sure you have all the tools you need and plenty of rags or newspapers to mop up spills before beginning. This can be achieved by using a hoist, ramps or jack stands that will enhance easy access under the vehicle. Park it on level ground then start its engine and let it warm up to normal operating temperature. Turn off the ignition switch, take off the oil filler cap and raise your car with jackstands. Remove the splash shield from underneath the engine and place a drain pan below this opening for used oil. Take out the plug gently letting old lubricant flow into your pan. Check if there are any pieces of metal in it that may suggest internal wear of your engine components. Finally, wipe clean around drain plug prior to reinstallation and tightening. Move under filter for more loosening as well as unscrewing using a filter wrench then also wipe off mounting surface at block without leaving any of these old gasket material behind in order to get rid of leaks during installation process.. Apply some oil on this new filter's rubber gasket then screw it tight enough into place once again as I remove all those tools back down where they belong finishing at lowering my vehicle afterwards since everything has been done now. Pour three quarts through an opening of an oil filler cap so that dipstick can show what level should be seen after starting another engine but such information will not come out immediately until this component stops leaking during first few moments when oils begin flowing downwards towards crankcase in front before making sure whether more is required there still or not while probably waiting instead just like everyone else has always done; however please remember never try overfilling container above maximum indicated levels either since such action might spill onto exhaust manifold case thereby igniting fire which would destroy whole automobile along with environment itself.

Genuine Subaru Outback Oil Filter

Engine Oil filter

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

12 Oil Filters found

View related parts
Subaru Outback Elem Complete Oil Filter
Part Number: 15208AA100
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaces: 15208AA023, 15208AA021, 15208AA080, 15208AA12A, 15208AA020, 15208AA024, 15208AA060, 15208AA09A, SOA6351520812, 15208AA022
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 1996-2012 Subaru Outback | 2.5GT Limited, 2.5GT Premium, 2.5i, 2.5i Base, 2.5i Limited, 2.5i Premium, Baja, Baja-B, Baja-S, Base, Brighton, Cold Weather, GT, GT Limited, L, L-S, Limited, LS, LS-I, Out Back, Post, SUS, SUS Limited, XT Limited | 2.2L H4, 2.2L H4 (New EVAPO), 2.2L H4 Series, 2.5L H4, 2.5L H4 SOHC, 2.5L H4 Turbo
View related parts
Subaru Outback Oil Filter Complete
Part Number: 15208AA15A
$7.02 MSRP: $9.75
You Save: $2.73 (28%)
ADD TO CART
Product Specifications
- Other Name: Oil Filter
- Replaced by: 15208AA21A
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2013-2021 Subaru Outback | 2.4R F/R-O, 2.4R Limited, 2.4R Touring, 2.5i, 2.5i Limited, 2.5i Premium, 2.5i Sport, 2.5i Touring | 2.4L H4 DIT, 2.5L H4, 2.5L H4 DI, 2.5L H4 DOHC
View related parts
Subaru Outback Oil Filter
Part Number: 15208AA031
$9.18 MSRP: $12.75
You Save: $3.57 (28%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaces: 15208AA030, SOA5165109
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2001-2019 Subaru Outback | 3.0R, 3.0R Limited, 3.0R LL-Bean, 3.6R, 3.6R Limited, 3.6R Premium, 3.6R Touring, Flat6, Flat6 L.L.Bean, Flat6-S, SUS Flat6 | 3.0L H6, 3.6L H6
View related parts
Subaru Outback Elem Complete Oil Filter
Part Number: 15208AA12A
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete; Oil Filter
- Replaced by: 15208AA100
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2009-2012 Subaru Outback | 2.5GT Limited, 2.5GT Premium, 2.5i, 2.5i Base, 2.5i Limited, 2.5i Premium, Base, GT, GT Limited, XT Limited | 2.5L H4, 2.5L H4 SOHC, 2.5L H4 Turbo
View related parts
Subaru Outback PT120103 Oil Filter
Part Number: 15208AA060
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaced by: 15208AA100
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 1997-2005 Subaru Outback | 2.5i, 2.5i Limited, Baja, Baja-S, Base, Brighton, Cold Weather, GT, L, Limited, LS, L-S, LS-I, Out Back, Post, SUS, SUS Limited | 2.2L H4 , 2.2L H4 (New EVAPO), 2.2L H4 Series, 2.5L H4
View related parts
Subaru Outback PT120103 Oil Filter
Part Number: 15208AA024
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaced by: 15208AA100
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 1997 Subaru Outback | GT, LS-I, Out Back, SUS | 2.5L H4
View related parts
Subaru Outback PT120103 Elem Complete Oil FILT
Part Number: 15208AA080
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaced by: 15208AA100
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2004-2005 Subaru Outback | Baja-B, GT, GT Limited | 2.5L H4 Turbo
View related parts
Subaru Outback Oil Filter 65MM
Part Number: 15208AA09A
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaced by: 15208AA100
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2006 Subaru Outback | 2.5i, 2.5i Limited, GT, GT Limited | 2.5L H4, 2.5L H4 Turbo
View related parts
Subaru Outback Oil Filter
Part Number: 15208AA023
$6.64 MSRP: $9.22
You Save: $2.58 (28%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Oil Filter Complete
- Replaced by: 15208AA100
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 1996-1997 Subaru Outback | Brighton, GT, L, LS, LS-I, Out Back, Post, SUS | 2.2L H4 , 2.2L H4 (New EVAPO), 2.5L H4
View related parts
Subaru Outback ELEM CP-OIL FLTR
Part Number: 15208AA21A
$7.02 MSRP: $9.75
You Save: $2.73 (28%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Replaces: 15208AA15A, 15208AA20A, 15208AA160, SOA6351520815
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2024-2025 Subaru Outback | 4 Cyl 2.4L, 4 Cyl 2.5L
View related parts
Subaru Outback ELEM CP-OIL FLTR
Part Number: 15208AA20A
$7.02 MSRP: $9.75
You Save: $2.73 (28%)
ADD TO CART
Product Specifications
- Replaced by: 15208AA21A
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2022-2023 Subaru Outback | 4 Cyl 2.4L, 4 Cyl 2.5L
View related parts
Subaru Outback OIL FILTER COMPLETE
Part Number: SOA6351520815
$7.02 MSRP: $9.75
You Save: $2.73 (28%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Replaced by: 15208AA21A
- Warranty: This genuine part is guaranteed by Subaru's factory warranty.
Fits the following Vehicles:
- 2022-2023 Subaru Outback | 4 Cyl 2.4L, 4 Cyl 2.5L

Subaru Outback Oil Filter

The function of a Subaru Outback Oil Filter is to keep your oil clean and accessible to your engine down the road. It will trap any contaminants while leaving sufficient flow for thousands of miles. The filter media incorporated within the Oil Filter is proprietary cellulose, synthetic fibers, or a combination of both and is designed to trap dirt before circulation to prevent blockage of engine components. The component's efficiency rating can reach 99 percent. As a result, it removes 99 out of every 100 contaminant particles. Consequently, this lessens wear, corrosion, and sludge. Capacity similarly matters; the filter must be capable of collecting and retaining debris until the next oil and filter change without being filled up. The Outback engine can resist performance loss from sludge buildup with a maintained Oil Filter. To avert the oil from starving or running dry, the designs incorporate pressure relief and anti-drainback valves that maintain oil pressure while starting the engine or under high demand. The Oil Filter replacement goes along with oil changes for Outback models of the Subaru component. The Oil Filter ensures that the lubricating oil always reaches where it is needed for stable operation and long engine life in the Subaru Outback, giving Subaru owners peace of mind in reliability.

Our website stands as the go-to online destination for OEM Subaru Outback Oil Filter. With complete lines of genuine Subaru Outback Oil Filter available at unbeatable market prices, we ensure top quality, reliability, and durability. Each part comes backed by the manufacturer's warranty, reinforcing your trust in our offerings.

Subaru Outback Oil Filter Parts Questions & Experts Answers

Oil Filter Complete
15208AA15A
Q:
How to perform an oil and oil filter change and properly disposing of the used oil on Subaru Outback?
Posted by Andrea M.
A:
The engine is best served by having the oil changed regularly because with time, the old oil becomes diluted and contaminated causing a premature engine wear. Make sure you have all the tools you need and plenty of rags or newspapers to mop up spills before beginning. This can be achieved by using a hoist, ramps or jack stands that will enhance easy access under the vehicle. Park it on level ground then start its engine and let it warm up to normal operating temperature. Turn off the ignition switch, take off the oil filler cap and raise your car with jackstands. Remove the splash shield from underneath the engine and place a drain pan below this opening for used oil. Take out the plug gently letting old lubricant flow into your pan. Check if there are any pieces of metal in it that may suggest internal wear of your engine components. Finally, wipe clean around drain plug prior to reinstallation and tightening. Move under filter for more loosening as well as unscrewing using a filter wrench then also wipe off mounting surface at block without leaving any of these old gasket material behind in order to get rid of leaks during installation process.. Apply some oil on this new filter's rubber gasket then screw it tight enough into place once again as I remove all those tools back down where they belong finishing at lowering my vehicle afterwards since everything has been done now. Pour three quarts through an opening of an oil filler cap so that dipstick can show what level should be seen after starting another engine but such information will not come out immediately until this component stops leaking during first few moments when oils begin flowing downwards towards crankcase in front before making sure whether more is required there still or not while probably waiting instead just like everyone else has always done; however please remember never try overfilling container above maximum indicated levels either since such action might spill onto exhaust manifold case thereby igniting fire which would destroy whole automobile along with environment itself.
Answered by Subaru Parts Specialist Jesse / Sep 13, 2024