Subaru 86111AG001 Unit&Relay

The turn signals flash when the signal switch is turned on. Once pushed down, the hazard flasher switch will flash all four turn signal lights at once. It is under the instrument panel on the driver's side. An audible click can be heard when it works properly. In case one side or other of the indicators does not work and there is no clicking sound from a flasher unit, then there's an indication of a defective turn signal bulb if flashes occur much more quickly than they normally do. When both turn signals fail to blink, the problem may be caused by a blown fuse, defective flasher unit, broken switch or a loose or open connection. Check the wiring for a short before installing a new fuse if a quick check of the fuse box reveals that the turn signal fuse has blown out. To remove this unit you must remove knee bolster and reinforcement panel behind it in order to unplug electrical connector from flasher unit, remove mounting bolt and remove unit as necessary. Note: Later models have an 8-pin module located in same area; installation is reverse of removal.

To test a normally-open relay, an ohmmeter can be used to check for continuity between specific terminals in different power and ground configurations.