Subaru 37114AE02A Throttle Accelerator Cable Assembly

To replace the accelerator cable, loosen the locknut and disengage the cable from the cable bracket, disconnect the cable from the throttle lever cam, trace the cable back to the firewall and detach any cable clips or guides, working inside the vehicle, up under the dash, disengage the other end of the cable from the accelerator pedal, pry out the grommet in the firewall, then remove the cable through the firewall from the engine compartment side. Installation is the reverse of removal, making sure the cable is routed correctly, and if necessary, applying sealant around the accelerator cable to prevent water from entering the passenger compartment. To adjust the accelerator cable, turn the adjusting nut to produce just enough cable slack so that the throttle plate is fully closed when the accelerator pedal is released, and have an assistant help you verify that the throttle plate opens all the way when you depress the accelerator pedal to the floor and that it returns to the idle position when you release the accelerator. Verify the cable operates smoothly and it must not bind or stick.

To install the accelerator cable, you should route it correctly, ensuring it is properly positioned. If necessary, apply sealant around the accelerator cable to prevent water from entering the passenger compartment.