Subaru 12013AB210 Piston Set RH

Position the piston at bottom dead center by turning the crankshaft. Then, insert needle-nose pliers through the service holes to remove the cir clips. Use a small flashlight to ensure the cir clip is positioned directly at the access hole, and make small movements of the crankshaft if needed to align the piston correctly.

Rotate the crankshaft until the number one and two connecting rods are at bottom dead center, aligning them with the center of the cylinder. Gently guide the number one piston into the cylinder, ensuring that the mark on the piston crown faces the front of the engine. Tap the exposed edge of the ring compressor to ensure contact with the crankcase. Carefully tap on the top of the piston with a wood or plastic hammer handle to push it into the cylinder, maintaining pressure on the ring compressor. If any resistance is felt, stop immediately and address the issue.